Checking Conditioner Roll Timing - MacDon R85 Assembly Instructions Manual

4.5.2 Checking Conditioner Roll Timing

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully to the ground.
2. Shut down the engine and remove the key.
3. Header should be on the ground and windrower should
be shut down. Ensure key is removed from ignition.
4. Open driveshield. For instructions, refer to
Driveshields, page 75.
5. Remove bolt (A) and nut, and remove gauge (B) from
flanged frame member.
214367
PERFORMING PREDELIVERY CHECKS
3.15.1
89
B
Figure 4.17: Roll Timing
A - Timing Gap
B
Figure 4.18: Roll Timing Gauge in Storage
Position
A
B - Crop
A
Revision A