MacDon R85 Assembly Instructions Manual page 40

CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
3. Activate the REEL UP switch (A) on the GSL to raise
the center-link until the hook is above the attachment
pin on the header.
4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
214367
ASSEMBLING THE HEADER
Figure 3.50: Ground Speed Lever
Figure 3.51: Ground Speed Lever
Figure 3.52: Header Support
32
A
A
B
A
Revision A