Lubricating The Header; Driveshields; Opening The Driveshield: North American Headers; Closing The Driveshield: North American Headers - MacDon R85 Assembly Instructions Manual

3.15 Lubricating the Header

The header has been lubricated at the factory. However, you should lubricate the header prior to delivery to offset
the effects of weather during outside storage and transport, and to familiarize yourself with the header.

3.15.1 Driveshields

WARNING
Do NOT operate the machine with the driveshields open. High-speed rotating components may throw
debris and could result in death or serious injury.
Access to the header drive systems requires opening the driveshield at the left end of the header. When a
procedure only applies to one configuration, the configuration is specified in the procedure title.

Opening the Driveshield: North American Headers

Follow these steps to open the driveshield on North American headers:
1. Release rubber latches (A).
2. Lift shield (B).

Closing the Driveshield: North American Headers

Follow these steps to close the driveshield on North American headers:
1. Lower shield (B) so that pins at lower end of shield
engage holes in lower panel.
2. Engage rubber latches (A).
214367
ASSEMBLING THE HEADER
Figure 3.154: Driveshield
Figure 3.155: Driveshield
75
B
A
B
A
Revision A