Ny-Series Instructions Reference Manual (W560 - Omron NY532-5400 Reference Manual

Value of
ErrorID
16#2C00
16#2C01
16#2C02
16#2C05
16#2C07
16#2C08
Sample Programming
Two modes are created in a program: maintenance mode and run mode.
With this sample, if the button to read the total power ON time is pressed while in maintenance mode,
the total power ON time of Unit 3 (set in advance) is read.
If the total power ON time exceeds 5 years, a lamp is lit to indicate that the Unit replacement is neces-
sary.
If the button for completion of Unit replacement is pressed after replacing the Unit, the Unit replacement
warning lamp turns OFF.
The following system configuration is used.
Unit
Unit 1
Unit 2
Unit 3
Definitions of Variables
LD
Internal
Variables
Maintenance_Mode
Run_Mode
PushButton_Read
PushButton_Changed
Lamp_Warning_UnitLifeTime
Read
instance

NY-series Instructions Reference Manual (W560)

Value of
ErrorIDEx
16#80040000
16#81000000
An error occurred in the communications network.
16#82010000
Check the Unit and cable connections.
16#82040000
Make sure that the power supply to the Unit is ON.
16#82050000
16#90000000
The number of instructions that can be simultaneously executed was
16#00000000
exceeded.
16#00000000 A timeout occurred during communications.
An error occurred in the EtherCAT network.
---
Check the value of UnitProxy and the EtherCAT network configuration.
A slave that cannot be specified for the instruction was connected at the
16#00000000 slave node address of the specified Unit. Check the value of UnitProxy
and the EtherCAT network configuration.
16#00000000 The total power ON time could not be read.
Description
NX Unit (ID)
NX Unit (OD)
NX Unit (Unit from which to read the total power ON time)
Variable
Meaning
Initial
Data type
value
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
NX_ReadTotal-
PowerOnTime
2 Instruction Descriptions
Comment
Maintenance mode
Run mode
Reading the total power ON time
Completion of Unit replacement
Unit replacement warning
2
2-859