Omron NY532-5400 Reference Manual page 910

2 Instruction Descriptions
Value of
ErrorID
16#2C00
2-858
Value of
ErrorIDEx
The status of the specified Unit does not agree with the value of the read
source or write destination NX object.
Take the following actions if the value of Obj.Index is between 0x6000
and 0x6FFF or between 0x7000 and 0x7FFF.
16#0000 2230
• Delete the read source or write destination NX object from the I/O allo-
cation settings.
• Reset the error for the specified Unit.
• Place the specified Unit in a mode that does not allow writing data.
Instruction execution was not possible because the specified Unit was
performing initialization.
16#0000 2231
Wait for the Unit to start normal operation and then execute the instruc-
tion.
Hardware access failed.
16#0000 250F
Execute the instruction again.
16#0000 2601
The specified Unit does not support this instruction.
16#0000 2602
Check the version of the Unit.
16#0010 0000
Execution of the instruction failed.
Execute the instruction again.
16#0000 2603
Make sure that at least one channel is enabled in the selections of the
channels to use.
The NX Unit is not in a status in which it can acknowledge the instruction.
16#0000 2621
Wait for a while and then execute the instruction again.
The specified Unit does not exist.
16#0001 0000
Make sure that the Unit configuration is correct.
The specified port number does not exist.
16#00110000
Make sure that the Unit configuration is correct.
16#0012 0000
The value of UnitProxy is not correct.
16#0013 0000
Set the variable that indicates the specified EtherCAT Coupler Unit
16#0015 0000
again.
16#0016 0000
The specified node address is not correct.
16#0014 0000
Make sure that the Unit configuration is correct.
16#0030 0000 The specified Unit is busy.
16#8001 0000 Execute the instruction again.
The specified Unit is not supported for connection.
16#0031 0000
Check the version of the Unit.
16#8000 0000
16#8005 0000
16#8101 0000
16#8102 0000
16#8202 0000
16#8203 0000 An error occurred in the communications network.
16#8206 0000 Execute the instruction again.
to
16#8FFF0000
16#9001 0000
to
16#FFFE0000
16#8002 0000
16#8003 0000 An error occurred in the communications network.
16#8103 0000 Reduce the amount of communications traffic.
16#8200 0000
Meaning
NY-series Instructions Reference Manual (W560)