Ny-Series Instructions Reference Manual (W560 - Omron NY532-5400 Reference Manual

Value of ErrorID
16#2C00
16#2C01
16#2C02
16#2C05
16#2C07
Version Information
A CPU Unit with unit version 1.05 or later and Sysmac Studio version 1.06 or higher are required
to use this instruction.
Sample Programming
Refer to the sample programming for the NX_WriteObj instruction (page 2-946).

NY-series Instructions Reference Manual (W560)

Value of ErrorIDEx
The specified node address is not correct.
16#00140000
Make sure that the Unit configuration is correct.
16#00300000 The specified Unit is busy.
16#80010000 Execute the instruction again.
The specified Unit is not supported for connection.
16#00310000
Check the version of the Unit.
16#80000000 An error occurred in the communications network.
16#80050000 Execute the instruction again.
16#81010000
16#81020000
16#82020000
16#82030000
16#82060000
to
16#8FFF0000
16#90010000
to
16#FFFE0000
16#80020000 An error occurred in the communications network.
16#80030000 Reduce the amount of communications traffic.
16#81030000
16#82000000
16#80040000 An error occurred in the communications network.
16#81000000 Check the Unit and cable connections.
16#82010000 Make sure that the power supply to the Unit is ON.
16#82040000
16#82050000
16#90000000
An attempt was made to queue more than 192 NX_ChangeWrite-
16#00000000
Mode and RestartNXUnit instructions.
16#00000000 A timeout occurred during communications.
An error occurred in the EtherCAT network.
---
Check the value of UnitProxy and the EtherCAT network configu-
ration.
A slave that cannot be specified for the instruction was connected
16#00000000 at the slave node address of the specified Unit. Check the value
of UnitProxy and the EtherCAT network configuration.
2 Instruction Descriptions
Meaning
2
2-847