Removing and installing gear pedal
X
Tightening torque:
Gear pedal to frame ..................................... 41 Nm
Removing gearbox
e
Caution:
Switch off ignition.
Disconnect earth (ground) lead from battery.
Insulate earth (ground) lead.
•
Attach stand, BMW No. 00 1 520, to motorcycle.
•
Remove seat.
•
Remove side trim.
•
Remove fuel tank.
•
Remove rear wheel.
•
Detach rear brake caliper.
•
Detach ABS sensor.
•
Detach speedometer signal sensor.
•
Detach wire protection at swinging arm.
•
Tie up swinging arm with a suitable strap.
•
Remove suspension strut.
L
Note:
Press to rear at top.
•
Pull swinging arm upwards with strap.
•
Removing exhaust manifold.
•
Remove silencer (muffler).
•
Detach plug at oxygen sensor.
•
Remove rear wheel drive unit.
•
Detach brake hose holder.
C230180
•
Press off left swinging arm bearing cap.
e
Caution:
When installing again, make sure that the O-ring is
in good condition.
The opening must face down so that water can drain
out.
•
Loosen the left swinging arm.
•
Take out the screws at the right swinging arm
bearing.
00 8 582
•
Using pull rod, BMW No. 00 8 581, and impact
weight, BMW No. 00 8 582, pull out the swinging
arm bearing.
•
Remove the left swinging arm bearing.
•
Remove rear swinging fork.
•
Remove the rubber intake pipe sleeves.
•
Remove brake fluid reservoir from holder.
•
Remove the holder.
•
Detach the right plug holder plate.
•
Pull off the NTC air plug.
•
Detach the gear pedal at the pivot.
•
Separate the throttle potentiometer and throttle
angle positioner plugs at the left plug holder
plate.
•
Disconnect both fuse boxes at the plug holder
plate.
C330030
00 8 581
C330040
23.5