Front Turn Indicator; Removing And Installing Front Turn - BMW S 1000RR Rider's Manual

with anti-theft alarm system
7
(DWA) OE
134
Install bracket 3 for anti-theft
alarm system.
Install body-bound rivet 2.
Fasten connector 1 for license-
z
plate carrier.
Insert anti-theft alarm system 2
while hooking into bracket 3.
Install screw 4.
Connect connector 1 for anti-
theft alarm system.
Thread connector 1 with cable
through lower rear section 2.
Connect connector 1, position
and fasten cable tie (arrow).
NOTICE
If the light defect warning
message for racetrack use is
suppressed in the display, this
must be activated in the
EQUIPMENT
submenu
SETUP EQIP:
under the
WARN LAMP ON
function
before the motorcycle is put into
operation in road traffic.
Install the passenger seat
( 62).
Removing and installing

front turn indicator

Remove front turn signal
NOTICE
The working steps described
here for the right turn indicator
SETUP