Salicru CV30 User Manual page 84

Function
Name
code
Communication
P14.03
answer delay
Communication
P14.04 overtime fault
time
Transmission
P14.05 fault
processing
Communication
P14.06 processing
action selection
84 - 140
Detailed instruction of parameters
13: Even check（E,8,1）for ASCII
14: Odd check（O,8,1）for ASCII
15: No check（N,8,2）for ASCII
16: Even check（E,8,2）for ASCII
17: Odd check（O,8,2）for ASCII
0~200ms
It means the interval time between the interval time when the
drive receive the data and send it to the upper monitor. If the
answer delay is shorter than the system processing time,
then the answer delay time is the system processing time. If
the answer delay is longer than the system processing time,
then after the system deal with the data, waits until achieving
the answer delay time to send the data to the upper monitor.
0.0 (invalid), 0.1~60.0s
When the function code is set as 0.0, the communication
overtime parameter is invalid.
When the function code is set as non-zero, if the interval time
between two communications exceeds the communication
overtime, the system will report "RS485 communication
faults" (CE).
Generally, set it as invalid; set the parameter in the
continuous communication to monitor the communication
state.
0: Alarm and stop freely
1: No alarm and continue to run
2: No alarm and stop according to the stop means (only
under the communication control)
3: No alarm and stop according to the stop means (under all
control modes)
0x00~0x11
LED ones:
0: Operation with response. The drive will respond to all
reading and writing commands of the upper monitor.
1: Operation without response. The drive only responds to
the reading command other than the writing command of the
drive. The communication efficiency can be increased by this
method.
Default
Modify
value
○
5
○
0.0s
○
0
○
0x00
Fault Tracking