Salicru CV30 User Manual page 58

Function
Name
code
Parameter
P07.01
copy
Key
P07.02 function
selection
QUICK/JOG
P07.03
the shifting
58 - 140
Detailed instruction of parameters
00000: Clear the previous user's password, and make the
password protection invalid.
After the user's password becomes valid, if the password is
incorrect, users cannot enter the parameter menu. Only
correct password can make the user check or modify the
parameters. Please remember all users' passwords.
Retreat editing state of the function codes and the password
protection will become valid in 1 minute. If the password is available,
press PRG/ESC to enter into the editing state of the function codes,
and then "0.0.0.0.0" will be displayed. Unless input right password,
the operator can not enter into it. Note: Restoring to the default value
can clear the password, please use it with caution.
0: No operation
1: Upload the local function parameters to the keypad
2: Download the keypad function parameters to the
inverter (including all the motor parameters)
3: Download the keypad function parameters to the
inverter (excluding the motor parameter of P02 group)
4: Download the keypad function parameters to the
inverter (only for the motor parameters of P02 group)
Note: After finish 1~4, the parameter will restore to 0
0x00~0x27
Ones：QUICK/JOG key function
0：No function
1：Jogging running
2：Switch display state as shift key
3：Switch between FWD/REV rotation
4：Clear UP/DOWN settings
5：Coast to stop
6：Switch running command ref. mode in order
7：Quick commission mode (based on non-default
parameters)
Tens:
0：keys unlocked
1：Lock all keys
2：Lock part of the keys (lock PRG/ESC key only)
When P07.02=6, set the shifting sequence of running
command channels.
Default
Modify
value
0
◎
0x01
◎
0 ○
Fault Tracking