Salicru CV30 User Manual page 49

Function
Name
code
S5 terminals
P05.05 function
selection
S6 terminals
P05.06 function
selection
S7 terminals
P05.07 function
selection
S8 terminals
P05.08 function
selection
HDI terminals
P05.09 function
selection
Polarity
P05.10 selection of the
input terminals
Function Parameters
Detailed instruction of parameters
10: Increasing frequency setting (UP)
11: Decreasing frequency setting (DOWN)
12: Cancel the frequency change setting
13: Shift between A setting and B setting
14: Shift between combination setting and A setting
15: Shift between combination setting and B setting
16: Multi-step speed terminal 1
17: Multi-step speed terminal 2
18: Multi-step speed terminal 3
19: Multi- step speed terminal 4
20: Multi- step speed pause
21: ACC/DEC time 1
22: ACC/DEC time 2
23: Simple PLC stop reset
24: Simple PLC pause
25: PID control pause
26: Traverse Pause (stop at the current frequency)
27: Traverse reset (return to the center frequency)
28: Counter reset
29: Torque control prohibition
30: ACC/DEC prohibition
31: Counter trigger
32: Reserved
33: Cancel the frequency change setting temporarily
34: DC brake
35: Reserved
36: Shift the command to the keypad
37: Shift the command to the terminals
38: Shift the command to the communication
39: Pre-magnetized command
40: Clear the power
41: Keep the power
42~60: Reserved
61: PID pole switching
62~63: Reserved
The function code is used to set the polarity of the input
terminals.
Set the bit to 0, the input terminal is anode.
Set the bit to 1, the input terminal is cathode.
Default
Modify
value
0
◎
0
◎
0
◎
0
◎
0
◎
0x000 ○
49 - 140