Salicru CV30 User Manual page 50

Function
Name
code
Switch filter
P05.11
time
Virtual
P05.12 terminals
setting
Terminals
P05.13 control running
mode
50 - 140
Detailed instruction of parameters
BIT8 BIT7
HDI S8
BIT3 BIT2
S4 S3
The setting range: 0x000~0x1FF
Set the sample filter time of S1~S4 and HDI terminals. If the
interference is strong, increase the parameter to avoid wrong
operation.
0.000~1.000s
0x000~0x1FF (0: Disabled, 1:Enabled )
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: S5 virtual terminal
BIT5: S6 virtual terminal
BIT6: S7 virtual terminal
BIT7: S8 virtual terminal
BIT8: HDI virtual terminal
Set the operation mode of the terminals control
0: 2-wire control 1. Comply the enable with the direction. This
mode is widely used. It determines the rotation direction by
the defined FWD and REV terminals command.
FWD
K1
REV
K2
COM
1: 2-wire control 2. Separate the enable from the direction.
FWD defined by this mode is the enabling ones. The
direction depends on the state of the defined REV.
BIT6 BIT5
S7 S6
BIT1 BIT0
S2 S1
Running
FWD REV
command
OFF OFF Stopping
Forward
ON OFF
running
Reverse
OFF ON
running
ON ON Hold on
Default
Modify
value
BIT4
S5
0.010s
0x000
0
Fault Tracking
○
◎
◎