Table of Contents
Advertisement
XPS-Q8 Controller
To modify the parameters of a stage, do the following:
1. Select a stage from the list. Click on "Modify".
2. Scroll down to the section that contains the parameters that will be modified.
Parameters that require quite common changes, are the minimum and the maximum
target positions of a rotation stage. For example, to enable larger rotations of a
rotation stage that is not configured as a Spindle, set the maximum target position to
a very high value and the minimum target position to a very low value. In this case it
is also required to disable the limit switches of the rotation stage, see stage manual
for details.
3. When done, click "Save" to apply the new values, or click "Cancel" if a mistake was
made.
4. To take the new values into account, reboot the controller or use "Restart
Application" button.
The same screen allows duplicating stages in the stages.ini (in most case some
parameters are modified as a second step) or to delete stages from the stages.ini.
51
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Software Tools
Advertisement
Table of Contents
