Table of Contents
Advertisement
XPS-Q8 Controller
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
4.7
SYSTEM – Auto Configuration
With the help of this screen, a quick, basic configuration of the XPS controller can be
done. Check/un-check those stage models that you want/don't want the XPS controller
to configure to. When done, click "Generate Configuration Files". The XPS controller
reboots. After re-booting, you are able to use the XPS controller in this basic
configuration. For further information, refer to chapter 3.8.1.
"Generate Configuration Files" deletes your current system.ini configuration file.
For troubleshooting a system, make sure that you have a copy of the original
system.ini file for recovery.
Under Driver Model and Stage Model, all motor drivers and Newport ESP compatible
stages seen by the XPS controller are listed. This screen also provides valuable
information for diagnosing or troubleshooting the system.
4.8
SYSTEM – Manual Configuration
Manual Configuration allows you to review the current system configuration or to
define a new one. See also chapter 3.8.2 for further information.
To create a new system configuration, define all motion groups that should belong to
that system. It is not possible to append a motion group to an existing configuration
from this tool. To define a new motion group, do the following:
1. Enter the name of the new group (My_XY_Group in this case). Click on "ADD" to
confirm the new group.
NOTE
40
Software Tools
Advertisement
Table of Contents
