Newport XPS-Q8 Users Manual, Software Tools And Tutorial page 135

XPS-Q8 Controller
Verify in the corresponding sections of the stages.ini:
For the X axis:
;--- Travels
MinimumTargetPosition =-3
HomePreset =0; unit
MaximumTargetPosition =3
The limit travels must be equal or within the X limit positions of the mapping files
(shown here +3 and -3).
For the Y axis:
;--- Travels
MinimumTargetPosition =-3
HomePreset =0; unit
MaximumTargetPosition =3
The limit travels must be equal or within the Y limit positions of the mapping files
(shown here +3 and -3).
For Z axis:
;--- Travels
MinimumTargetPosition =-1
HomePreset =0; unit
MaximumTargetPosition =1
The limit travels must be equal or within the Z limit positions of the mapping files
(shown here +1 and -1).
In the system.ini file:
;--- Mapping XYZ
XMappingFileName = XYZMapping_X.txt
XMappingXLineNumber = 7
Represents the errors
XMappingYColumnNumber = 7
in the X axis.
XMappingZDimNumber = 3
XMappingMaxPositionError = 0.00787
YMappingFileName = XYZMapping_Y.txt
YMappingXLineNumber = 7
Represents the errors
YMappingYColumnNumber = 7
in the Y axis.
YMappingZDimNumber = 3
YMappingMaxPositionError = 0.00534
ZMappingFileName = XYZMapping_Z.txt
ZMappingXLineNumber = 7
Represents the errors
ZMappingYColumnNumber = 7
in the Z axis.
ZMappingZDimNumber = 3
ZMappingMaxPositionError = 0.0003
; unit
; unit
NOTE
; unit
; unit
NOTE
; unit
; unit
NOTE
123 XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Motion Tutorial