XPS-Q8 Controller
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Once you are logged in, you can change the IP configuration by following the steps
described in section 3.5.4 or 3.5.5 depending on your configuration.
If you want to reset the IP address to the default factory setting, follow the section
3.5.4 to set the IP address back to 192.168.0.254.
3.6
Testing your XPS-PC Connection and Communication
To check if the XPS communicates with to the host computer, send a ping message
from the computer to the XPS. This is done through the Windows menu: Start->Run->,
then type: ping + IP address of the XPS. See the example below for the IP address
192.168.33.236:
If the XPS is connected and communicates properly, it replies in the terminal window
that appears after clicking on the OK button:
NOTE
26
User's Manual