Table of Contents
Advertisement
XPS-Q8 Controller
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
3.5.6
Recovering a lost IP configuration
If you want to recover a lost IP configuration, you need to connect the PC directly to the
REMOTE connector at the back of the XPS with the gray cross-over cable.
First, the IP address on the PC's Ethernet card must be set to match the fixed IP address
of the XPS in the REMOTE plug (192.168.254.254). Following is the procedure to set
the Ethernet card address.
This procedure is for the Windows XP operating system (almost similar process to
Windows 7):
1. Start Button > Control Panel > Network Connections (Network and Sharing).
2. Right Click on Local Area Connection Icon and select Properties.
3. Highlight Internet Protocol (TCP/IP, TCP/IP4) and click on Properties.
4. Type the following IP address and Subnet Mask as shown in the next figure.
Figure 15: Direct connection to the XPS
using a cross-over cable and the REMOTE connector.
24
User's Manual
Advertisement
Table of Contents
