Table of Contents
Advertisement
XPS-Q8 Controller
21.0
Appendix C: Power Inhibit Connector
This connector is provided for the wiring of a remote STOP ALL switch.
It has the same effect as the front panel STOP ALL button.
Inhibition input is a standard TTL input.
Inhibition (Pin #2), must always be connected to GND during normal controller
operation.
An open circuit is equivalent to pressing STOP ALL on the front panel. Wire the switch
contacts normally closed.
Connecting more than one switch is not recommended on this input.
209
Figure 65: Inhibition connector.
NOTE
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Appendix
Advertisement
Table of Contents
