Table of Contents
Advertisement
XPS-Q8 Controller
11. Enter the positioner names.
Any positioner name can be used. In this example the X positioner name is
ILS150CC_UPPER. The home sequence can be either "Together" or "X then Y".
The other fields refer to the error compensation (mapping) of the XPS controller, see
chapter
10.0
for details. For the first configuration, don't enter anything in these
fields.
12. Click on "VALID" to get following screen:
13. Enter the appropriate PlugNumber. The plug number is the axis number where the
stage is physically connected to the XPS controller. Looking at the rear of the
controller, plug number 1 is the first plug on the right and the number increases to
the left.
14. Select the StageName from the list of stages. These stage names refer to the stages
defined with the Web Tool "Stage Management".
15. Specify the Time Flash Base Frequency value, the default is 40e
39.5 e
6
and 40.5 e
6
Hz).
16. Checking the box "Use a secondary Positioner" assigns a secondary positioner for a
gantry configuration. For details about gantries, please refer to section 4.9. Don't
check this box for a regular XY group or for a regular SingleAxis group.
33
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
User's Manual
(must be between
6
Advertisement
Table of Contents
