Table of Contents
Advertisement
XPS-Q8 Controller
"Generate config files and Boot" deletes the current system.ini file. To create a
copy of the current system.ini file, retrieve this from the "..admin\config" folder of
the XPS controller.
The following screen appears:
Click on "OK".
6. When the controller has finished booting (second beep after 12-18 seconds), select
the SYSTEM tab, then "Error File Display". When there is no entry in the error
file, your system is configured correctly and ready to use. If not, this file provides
some valuable information for troubleshooting; see also chapter 4.5.
This is an example of a system.ini file with one XY group and one Spindle group:
[GENERAL]
BootScriptFileName =
BootScriptArguments =
[GROUPS]
SingleAxisInUse =
SpindleInUse = Spin
XYInUse = My_XY_Group
XYZInUse =
MultipleAxesInUse =
[My_XY_Group]
PositionerInUse = StepAxis,ScanAxis
InitializationAndHomeSearchSequence = Together
;--- Mapping XY
XMappingFileName =
YMappingFileName =
[My_XY_Group.StepAxis]
PlugNumber = 3
StageName = VP-25XA-SECONDARY
[My_XY_Group.ScanAxis]
PlugNumber = 4
StageName = VP-25XA-PRIMARY
[Spin]
PositionerInUse = Rot
[Spin.Rot]
PlugNumber = 2
StageName = URS100CC_Spindle
43
NOTE
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Software Tools
Advertisement
Table of Contents
