Table of Contents
Advertisement
XPS-Q8 Controller
User's Manual
Once logged in, the XPS has established a direct connection to the local computer.
If you don't want to connect the XPS controller through a Corporate Network you may
skip to section 3.7: "Connecting the Stages".
NOTE
If you want to change the IP address of the XPS controller, follow the explanation
in the next section. It is necessary to keep using the gray cross-over Ethernet cable
to connect the XPS controller directly to the PC.
3.5.4
Connecting the XPS to a Corporate Network using Static IP Configuration
Once you are logged in using the previously described steps for direct connection, you
can change the IP configuration of the controller in order to connect the XPS over a
Network. Select "CONTROLLER CONFIGURATION" of the web-site and select the
sub-menu "IP Management".
The static IP address, the subnet mask and the Gateway IP address must be provided by
your Network Administrator to avoid network conflicts. Once you have these addresses,
you can input them in the IP configuration window as shown above. The above shown
addresses are only examples.
19
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
Advertisement
Table of Contents
