XPS-D Controller
7.0
Appendix C: Power Inhibit Connector
EDH0395En1031 – 09/18
7.1
Description
Inhibit in XPS is a female BNC Connector intended for wiring a remote STOP ALL
switch. (If not used, the BNC plug must remain in place to allow operation)
The BNC pin is connected to XPS inhibit and BNC outer shell is connected to GND.
For normal operation of the XPS, the Inhibit must be connected to GND in order to
work. When inhibit is open the drivers power supply is switched OFF
Figure 29: Inhibition connector.
42
Start-Up Manual