Functions Of The Web Server - Siemens PSU8600 Manual

Engineering and remote access
7.7 Web server
The language selection
German, English, French, Italian, Spanish, and Chinese are available as languages.
Click on the "Logout"
server can only be accessed by logging in again.
You can download the license information of the PSU 8600 system using the "License
information"
Grayed out menus
When SITOP PSU8600 was assigned a SIMATIC S7 control system as IO device, then the
web server is in the read-only mode. The following applies in the read-only mode:
● Parameters cannot be write accessed. Parameters can only be read (input values are
grayed out).
● The firmware can still be updated.
● It is still possible to save and delete the alarm list.
If the SITOP PSU8600 is operated in the MANUAL operating mode, certain parameters -
directly set at the hardware or specified parameters - cannot be changed using the web
server.
These parameters include, e.g. the setting values for current and voltage - and functions that
can be set via DIP switch.
7.7.4

Functions of the web server

The functions of the web server are split up between the two menus "Diagnostics" and "HW
Configuration". Use the "Download to device" function to load changes that you have made
to the device, see Loading the configuration (commissioning) (Page 206).
Diagnostics
You can find the following submenus here:
● Alarms, for an overview of past and active alarms, see Alarms (Page 206).
● Operating data, for an overview of operating data, see Operating data (Page 208).
● Online functions, with the options:
– Switch output on/off
– Buffering on/off (only if there is a minimum of 1 buffer module available in the system)
– Firmware update
– Reset system
– Restoring the factory setting
For the online functions, see Online functions (Page 210).
204
⑤
is used to select the user interface language of the web server.
④
button to log out from the current web server session. The web
③
button.
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76