Functions Of The Web Server - Siemens SITOP PSU8600 Manual

Engineering and remote access
7.7 Web server
Grayed out menus
When SITOP PSU8600 was assigned a SIMATIC S7 control system as IO device, then the
web server is in the read-only mode. The following applies in the read-only mode:
● Parameters cannot be write accessed. Parameters can only be read (input values are
grayed out).
● The firmware can still be updated.
● It is still possible to save and delete the alarm list.
If the SITOP PSU8600 is operated in the MANUAL operating mode, certain parameters -
directly set at the hardware or specified parameters - cannot be changed using the web
server.
These parameters include, e.g. the setting values for current and voltage - and functions that
can be set via DIP switch.
7.7.4

Functions of the web server

The functions of the web server are split up between the two menus "Diagnostics" and "HW
Configuration". Use the "Download to device" function to load changes that you have made
to the device, see Chapter "Loading the configuration (commissioning) (Page 277)".
Diagnostics
You can find the following submenus here:
● Alarms, for an overview of past and active alarms, see Chapter "Alarms (Page 278)".
● Operating data, for an overview of operating data, see Chapter "Operating data
(Page 279)".
● Online functions, with the options:
– Switch output on/off
– Buffering on/off (only if there is a minimum of 1 buffer module available in the system)
– Battery capacity test (if the system has at least 1 battery module)
– Firmware update
– Reset system
– Reset to factory settings
For the online functions, see Chapter "Online functions (Page 282)".
276
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76