Table of Contents
Advertisement
7.7.7
HW configuration
System synchronization
Note
If you add or remove modules, you must carry out a system alignment before you change
parameters.
A red frame is shown around the graphic if MANUAL configuration and REMOTE
configuration do not match.
The REMOTE configuration is displayed if, at the device, selector switch "REN" is set to ON.
If selector switch "REN" is set to OFF, then the configuration is shown the same as at the
device.
You can carry out the following synchronizations in the system.
● Synchronize configuration
Using function "Transfer MANUAL configuration to REMOTE configuration" (synchronize
configuration) you load the hardware configuration of all installed devices into the
REMOTE configuration of the system.
● Synchronize parameters
With function "Transfer MANUAL configuration to REMOTE configuration" (MANUAL >>
REMOTE) you load the parameterization (potentiometer and switch settings) of all
installed devices into the REMOTE configuration of the system.
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76
Engineering and remote access
7.7 Web server
213
Advertisement
Table of Contents
