Engineering and remote access
7.5 SIMATIC STEP 7
Subgroup
Output 1
Web server
General I&M
A detailed description of the individual parameters of the subgroups is provided in Sections
Parameterizing the basic unit (Page 159) and Parameterizing output 1 (Page 164).
Parameters of the expansion modules
Subgroups "Outputs 1 ... 4" are relevant when parameterizing expansion modules.
Subgroup
Outputs 1 ... 4
A detailed description of the individual parameters of the subgroups is provided in Section
Parameterizing output 1 (Page 164).
Parameters of buffer modules with electrolytic capacitors
With the exception of the standard settings for IO devices, the buffer modules with
electrolytic capacitors have no configurable parameters.
158
Description
In these subgroups, make the following settings for the individual out-
puts:
Switch-on and switch-off output.
•
Setpoint output voltage
•
Response threshold value of the output current
•
Define a threshold for the output of an alarm.
•
An alarm is output if this threshold is continually exceeded for 5 ms.
Define the on delay.
•
Define the ELECTRONIC SHUTDOWN or CONSTANT CURRENT
•
operating mode
Activate web server on this module
•
Activate automatic update.
•
Update interval
•
Activate automatic logoff
•
Permit access only with HTTPS.
•
Contact
•
Location ID
•
Description
In these subgroups, make the following settings for the individual outputs:
Switch-on and switch-off output.
•
Setpoint output voltage
•
Response threshold value of the output current
•
Define a threshold for the output of an alarm.
•
An alarm is output if this threshold is continually exceeded for 5 ms.
Define the on delay.
•
Define the ELECTRONIC SHUTDOWN or CONSTANT CURRENT operating
•
mode
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76