Table of Contents
Advertisement
Engineering and remote access
7.1
General information
Content of Chapter "Engineering and remote access"
This section describes the software tools offered by Siemens that are compatible with
SITOP PSU8600. The software tools are introduced with their functions, the associated
requirements and the operation. The software products are:
● SIMATIC STEP 7 in the TIA Portal
● SIMATIC STEP 7
Functions of the individual software products:
● SIMATIC STEP 7 in the TIA Portal
SITOP PSU8600 can be used with SIMATIC from STEP 7 V13 and higher in the
TIA Portal. After SITOP PSU8600 has been saved to the hardware catalog of
SIMATIC STEP 7 in the TIA Portal, it can be integrated into projects, parameterized and
diagnosed.
From SIMATIC STEP 7 V14 in the TIA Portal, versions of the SITOP PSU8600 – as well
as the supplementary modules - are already integrated in the hardware catalog and can
be directly used.
● SIMATIC STEP 7:
SITOP PSU8600 can be used with SIMATIC STEP 7 from Version 5.5 and higher. After
SITOP PSU8600 has been saved to the hardware catalog of SIMATIC STEP 7, it can be
integrated into projects, parameterized and diagnosed.
7.2
Addressing
7.2.1
MAC address
In a network, the SITOP PSU8600 is addressed using its physical MAC device address. This
is printed on the front side of the basic device.
Further, the basic devices are equipped with a 2 port switch, which can also be identified
using the following MAC addresses in the network:
● Ethernet port 1: MAC address of the basic device + "1"
● Ethernet port 2: MAC address of the basic device + "2"
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76
7
121
Advertisement
Table of Contents
