Table of Contents
Advertisement
Operator control at the device
3.10 Monitoring functions
● Red LEDs "ON/OFF/RST"
● The signaling contact at the basic unit
①
②
Reset of a shutdown due to system overload
After 60 s, the basic unit automatically returns to the normal operating state, the expansion
modules return to operational readiness. This state is signaled by:
● Green (in buffer operation, yellow) LED "OK"
● Green (in buffer operation, yellow) LED "OK"
● Red flashing LEDs "ON/OFF/RST"
Procedure
1. Press the LED buttons of the outputs at the expansion modules.
The LEDs in the buttons light up green. The outputs are switched-on again.
2. Alternatively, using a remote reset at terminal "RST", all outputs that have been shut
down can be simultaneously switched-on again.
80
②
LED "OK"
LED "ON/OFF/RST"
of the outputs of the expansion modules
①
at the basic unit
①
of the expansion modules
②
of the outputs of the expansion modules
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76
Advertisement
Table of Contents
