Siemens PSU8600 Manual page 198

Engineering and remote access
7.6 Cyclic and acyclic data
Data
Charging state
(0-100 %)
Buffer disabled by
input (0/255)
Fill byte(s)
LED color
LED state
198
Description
Charge state of the buffer module
Buffer component was deactivated via the control contact.
-
Actual LED color. Each
LED is represented by 2
bits:
Bit0/1: OK
•
Bit2-15: unused = 0
•
Actual display status of
the LEDs. Each LED is
represented by 2 bits:
Bit0/1: OK
•
Bit2-15: unused = 0
•
4 = ErrorOff Shutdown after an error:
A fault/error has occurred
when operating the buffer
component. The buffer
component is not opera-
tional and must be re-
started by switching off
the supply voltage and
switching it on again.
5 = NotFully Ready for buffer operation
ChargedReady as the energy storage
device of the buffer mod-
ule has been sufficiently
charged.
6 = NotFully Not ready for buffer oper-
ChargedNotReady ation as the energy stor-
age device of the buffer
module has not been
sufficiently charged and is
presently being charged.
0 LED is off.
1 LED lit green.
2 LED lit red.
3 LED lit yellow.
0 LED is off.
1 LED lights up.
2 LED flashes at 1 Hz.
3 LED flashes at 2 Hz.
Data type
Unsigned8
Unsigned8
Unsigned8
Unsigned16
Unsigned16
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76