Table of Contents
Advertisement
Engineering and remote access
7.7 Web server
The system starts up again after the system is reset. All supplementary modules are
internally addressed, the system configuration checked and the PROFINET connection to
the control re-established.
Using a system reset, it is not possible to switch-on outputs again after an automatic
shutdown.
Procedure
1. Select menu "Diagnostics".
2. Select submenu "Online functions".
3. Select the "Reset system" entry.
4. In the editor area, click on "Reset system".
5. Acknowledge the confirmation prompt with "OK".
Reset to factory settings
A reset to the factory settings deletes all hardware and software configurations stored in the
SITOP PSU8600 and restores the factory settings.
This affects, for example:
● IP address
● Device name
● Parameter values for the SITOP PSU8600 and assigned supplementary modules.
● "Web server activated" setting. Web server de-activated.
Procedure
1. Select menu "Diagnostics".
2. Select submenu "Online functions".
3. Select entry "Reset to factory setting".
4. In the editor area, click on "Reset to factory settings".
5. Acknowledge the confirmation prompt with "OK".
212
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76
Advertisement
Table of Contents
