Siemens PSU8600 Manual page 201

6. Wait for approximately two minutes until the SSL certificate has been generated.
7. Open the web browser and enter the new IP address in the address field of the browser.
8. Press "Logon".
Enter the logon information in the following logon page:
Initial values:
– User name: "admin"
– Password: "admin"
The start page of SITOP PSU8600 is opened. You can navigate to further menus from
the start page.
Activating the web server for the REMOTE operating mode
Proceed as follows if you wish to activate the web server for the REMOTE operating mode of
the SITOP PSU8600:
1. Navigate in menu "HW Configuration".
2. Navigate in the submenu "General" > "Web server" > "Settings".
3. In the editor area "General", set a checkmark to select "Activate web server on this
module".
The web server of the SITOP PSU8600 is now activated for access in the MANUAL and
REMOTE operating modes.
Using the web server in the REMOTE operating mode
Proceed as follows if you wish to use the web server in the REMOTE operating mode with
full write authorization:
1. Set DIP switch "REN" (Remote enable) at the basic device SITOP PSU8600 to "ON".
The SITOP PSU8600 is in the REMOTE operating mode.
Note
After switching over into the REMOTE operating mode, the SITOP PSU8600 continues to
operate without any changes. However, device parameters can only be changed via
remote access.
2. Click on the "Logout" button to log out from the current web server session.
The logon page opens.
3. Logon again (user name: "admin", password: "admin"), to access the web server in the
REMOTE operating mode.
The start page of SITOP PSU8600 is opened. You can navigate to further menus from
the start page.
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76
Engineering and remote access
7.7 Web server
201