Loading The Configuration (Commissioning) - Siemens PSU8600 Manual

Engineering and remote access
7.5 SIMATIC STEP 7
7.5.5

Loading the configuration (commissioning)

In the delivered state, the SITOP PSU8600 has not yet been assigned any IP address and
the DHCP protocol is deactivated.
When the SITOP PSU8600 is first connected with a controller (SIMATIC S7 control), it must
be assigned a device name and an IP address by the controller. A new configuration can be
loaded to the device with SIMATIC STEP 7.
Preconditions
● The SITOP PSU8600 has been correctly connected and linked with the network.
● PG/PC with SIMATIC STEP 7 is connected with the network.
Displaying accessible nodes
Note
If nodes can only be accessed via interposed switches or routers (with protocol conversion),
they are not displayed in the list of the accessible nodes.
1. Click in the "Target system" menu on "Display accessible nodes"
The "Accessible nodes" window is opened with the following displays:
– Station
– SITOP PSU8600
The following table shows which information is displayed in the "Object name" column.
Accessible nodes
S7-CPU, PC station
Loading the IO controller for the first time
Once you have configured the SITOP PSU8600 and the station, you must load this
configuration into the IO controller (SIMATIC S7 control system). This is the way that the IO
controller is assigned its configured IP address.
Before loading, carry out a consistency test to check the configuration for duplicate
addresses, identical names, etc.
166
then limited to 100 % of the setting value (LED "ON/OFF/RST" flashes green with
1 Hz) as long as there is an overload condition.
Object name
Name of the station
Description
The "Details" view also shows the operating
state, module type and, if available, information
from the associated SIMATIC STEP 7 project
(station name, CPU name, system identification).
Power supply system PSU8600
Manual, 05.2017, A5E36758446-3-76