Figure 3-21 Signal Distribution On The Tme1 Module Connector - Siemens HiPath 1100 Service Manual

Modules
Expansion Modules (EB)
Connector for TME1 Module Configuration
The connector's function is to connect a PC or modem to a module using a serial cable (see
"TME1 Serial Cable" on page 3-68). This allows you to program the module using the E1 Trunk
Manager (E1 CAS access) or a S2M Maintenance tool (S2 access).
tool
Figure 3-21 Signal distribution on the TME1 module connector
Warning
!
Do not touch the TME1 module's administrative serial interface connector (X803)
without first disconnecting all analog extensions and trunk connectors. Failure to fol-
low this procedure may expose the user to dangerous voltages.
The administrative serial interface connector (X803) as well as all other connectors
and interconnect cables should only be serviced by trained technical personnel.
DIP Switch Positions for the TME1 Module
Figure 3-22 DIP Switch for the TME1 Module
3-37
9-pin
Mini DIN connector
9 7
6
3
2
1
1 = DCD 6 = DSR
2 = RX 7 = RTS
3 = TX 8 = CTS
4 = DTR 9 = RI
5 = GND
A31003-K1160-S100-03-7620
Service Manual