Local Connection; Serial Interface - Siemens HiPath 1100 Service Manual

With optiPoint
Remote or Local Connection
With an Analog Modem
With an ISDN modem using a S
6.2.1

Local connection

6.2.1.1 V.24 Serial Interface
For this option, HiPath 1100 applications must be installed. After restarting the computer
configure the settings on the CommServer.
Procedure:
1. Make sure the HiPath 1100 system is turned on.
2. Insert the HiPath 1100 CD in the CD drive;
If Auto-Run is not configured, go to the Start menu on Windows, click "Run" and then select
the "Browse" button in the dialog box. Open the file SETUP.EXE on the CD drive.
3. In the Setup window, select the language you want to use
4. A window will appear where you can select the software to be installed
5. Select the software components you wish to install and install them. For programming the
HiPath 1100 system, the following applications must be installed:
HiPath 1100 Manager
●
CommServer (installs automatically).
●
6. After installation of each component, a message is displayed indicating that the installation
was successfully completed. Click "Next" every time it appears;
7. Click "Finish" to close the installation window. This completes the software installation. If
Windows prompts for restarting, restart your computer.
8. After installation is completed, configure the Communication Server (see Figure 6-1).
Right-click the CommServer icon on the Windows status bar and select "Properties."
Specify these settings:
Connection Type
●
Baud Rate 19200 (Default) / 38400 / 57600 / 115200 baud
●
COM port
●
A31003-K1160-S100-03-7620
Service Manual
module
0
Programming the system using a PC
Operation
6-10
6-50
6-13
6-16
6-4