Siemens HiPath 1100 Service Manual page 309

Timer for Deactivating the Relay (173)
Specifies the length of time that the relay must remain closed.
If the closing time is set to "000," the relay will remain active until it is manually de-
activated.
External Ring for Activating the Relay (071)
This setting lets you use the relay to set a second signal (e.g., a ring) for a specified analog
extension.
Sensor Message (213)
After assigning a number, you can assign a message to the sensor. This message will be
transmitted to the assigned number when the sensor state is changed.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-71