Adsl Module; Relay And Sensor On The Hipath 1120 - Siemens HiPath 1100 Service Manual

Configuring the system specifically for the client
Comments about the System's Programming Codes
TME1 capacity for HiPath 1150 (100)
This setting allows you to increase the number of ports for the TME1 module from 15 (default)
to 20.
7.2.14

ADSL Module

This provides connection for network PCs for sharing ADSL access, without requiring a splitter,
modem, additional ADSL, hub or network cards in any of the PCs.
The PCs are connected to the HiPath 1100 which provides (via LAN) the same functions
provided by the V.24 serial interface for integrating the HiPath 1100 Manager, Interaction
Center Smart and billing applications.
To configure the ADSL module correctly you need information about the VPI/VCI protocols,
DNS servers, user name and password used by the carrier.
All the PCs must have a network card installed and must be on the same network as the ADSL
module used as a gateway for accessing the Internet.
When using an ADSL module, do not connect the V.24 serial interface adapter cable
to the PABX. All data is delivered through the network.
Restore ADSL Module Default Settings (013)
This code restores the default configuration of the ADSL module assuming an IP of 10.0.0.1.
7.2.15

Relay and sensor on the HiPath 1120

You can connect a Music module to the HiPath 1120 system. This module also provides a Relay
and a Sensor for integrating other devices such as an Entrance Telephone, a Door Opener etc.
Sensor:
When the state of a sensor changes (for example, when the sensor changes from an open
contact to a closed contact), the following functions can be executed:
Selection of a number in the Speed Dial Directory (Phonebook)
●
Activation of a relay
●
Dialing a number from the Speed Dial directory and activating a relay.
●
The activation logic based on the initial position of the sensor contacts as well as its resulting
actions are programmable.
7-68
A31003-K1160-S100-03-7620
Service Manual