Siemens HiPath 1100 Service Manual page 289

The modules can only be connected/disconnected when the system is turned off.
Type of MSN Signal (073)
This setting lets you choose one of the four types of rings for various calls, and a ring for
registered MSNs. The default configuration for MSNs is Type 1 ring.
Reference Clock (090)
This allows you to specify a module slot for the system's Reference Clock.
Assigning a Temporary MSN (093)
This feature allows you to use a temporary MSN from your own directory to make an external
call. Or, to use the "Key Assignment" feature to assign a key to a MSN for monitoring incoming
and outgoing calls (see Key Assignment - Using a Temporary MSN for Making a Call, in the
User Manual).
MSN Identification Mode (224)
This setting specifies how the MSN is shown on a system telephone display. In the default
configuration no Mode is configured.
This feature does not work when option 1 is selected in Code 039 "Caller ID/
Number".
Remote Administration Password through an MSN (220)
This setting allows you to specify a password so that all incoming calls from a remote HiPath
1100 Manager that provides the correct password can be authorized to execute Remote
Administration. In the default configuration, no password is set.
In order to enable this feature the option "Without MSN Verification Code" (Code
070) must be enabled.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-51