Siemens HiPath 1100 Service Manual page 269

Seizure priority by type of external line (194)
This setting specifies which type of external line will be seized when making an outgoing call.
External lines can be accessed using the access code "0" or the code specified for a group of
lines.
If the PABX has digital and analog lines, you can specify which type of line will have priority.
External analog line seizure protocol (017)
This feature specifies the protocol to be used by the system for seizing an external analog line,
based on the local carrier's information.
This features is only available for Canada.
Caller ID for Analog Lines (005)
Enabled by the local Carrier, this service provides Caller ID over FSK and DTMF protocols on
analog lines.
When a Country setting is specified, the appropriate protocol is automatically select-
ed.
External Line Call Direction (155)
Specifies how to access external lines when receiving or making a call.
An external line can be:
1 = Bidirectional
2 = Incoming unidirectional
3 = Outgoing unidirectional
Flash Duration on an Analog Line (118)
Specifies the time during which the Flash signal remains active on the external analog line in
relationship to the detection defaults set at the exchange.
Reseizure Timeout for an External Line (129)
This setting specifies the timeout to reseize the external line after a call has been completed.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-31