Adsl Module (Lan) - Siemens HiPath 1100 Service Manual

6.2.1.3

ADSL Module (LAN)

With this option an internal network access is used with an ADSL module. In order to do this,
HiPath 1100 applications must be installed. After restarting your computer, configure the
appropriate settings for the CommServer.
Procedure:
1. Insert the HiPath 1100 CD in the CD drive;
If Auto-Run is not configured, go to the Start menu on Windows, click "Run" and then select
the "Browse" button in the dialog box. Open the file SETUP.EXE on the CD drive.
2. In the Setup window, select the language you want to use
3. A window will appear where you can select the software to be installed
4. Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
HiPath 1100 Manager and
●
CommServer (installs automatically).
●
5. After installation of each component, a message is displayed indicating that the installation
was successfully completed. Click "Next" every time it appears;
6. Click "Finish" to close the installation window. This completes the software installation.
Windows may display a message to restart the computer. If this occurs, restart the
computer.
7. After installation is completed, configure the Communication Server (see Figure 6-4).
Right-click the CommServer icon on the Windows status bar and select "Properties."
1. Select ADSL connection
2. Specify the IP for the ADSL module:
When the .Obtain IP automatically. checkbox is selected, the CommServer will be
automatically configured with the computer's default gateway IP. Otherwise, the ADSL
module IP can be manually entered into the CommServer.
When an ADSL module is installed on a PABX, the
Interface cannot be used.V.24 serial
A31003-K1160-S100-03-7620
Service Manual
Programming the system using a PC
Operation
6-8