Optipoint Usb Drivers - Siemens HiPath 1100 Service Manual

Operation
Driver Installation
5. Uninstall CallBridge for Data Utilities (if previously installed to use online services or USB
connections) by running the Uninstall program as follows: Start/Programs/CallBridge for
Data Utilities/Uninstall CallBridge for Data Utilities. Once CallBridge for Data Utilities has
been uninstalled, answer "No" when asked if you want to restart your computer, and
proceed with step 6.
6. Uninstall all HiPath 1100 components as follows:
Start/Settings/Control Panel/Software, then click on "Remove Software";
7. Next, restart your computer.
6.3.2

optiPoint USB Drivers

There are two types of optiPoint USB drivers that can be installed for the HiPath 1100 system:
Administration USB driver or Administration USB driver + optiPoint CAPI interface.
If all you need is administration of the HiPath 1100 system, install the Administration USB
drivers. If in addition to HiPath 1100 system administration you wish to use CAPI services with
an optiPoint interface or perform CAPI administration using an optiPoint set, you must install
the optiPoint Administration + CAPI Interface USB drivers.
Administrator access is required for performing the installation under Windows
2000/XP .
If different PABX drivers or an ISDN card are already installed on the system, they
must be completely uninstalled before installing optiPoint's "CallBridge for Data."
6-33
A31003-K1160-S100-03-7620
Service Manual