4.7.9
Installing a Power Supply Unit
Introduction
Before connecting the power supply to the system, see "Technical Data" on page 2-8 " and
"Power Supply Unit (PSU)" on page 3-54.
4.7.9.1
On the HiPath 1120
Figure 4-29
Installing a Power Supply HiPath 1120
Procedure after Installation
Step
1.
Check network voltage
2.
If the voltage is within the power supply's voltage range, connect the power supply.
3.
"Performing a Visual Inspection" on page 4-59
4.
Configure the required data (see "Operation" on page 6-1).
Warning
!
To turn the power on or off to the system use the cable of the power supply.
A31003-K1160-S100-03-7620
Service Manual
Installation of Expansion and Option Modules
Procedure
Installation
4-35