Digital Trunk Settings - Siemens HiPath 1100 Service Manual

Voice Mail Group (215)
This setting specifies the UCD group to be used by the system.
Mailbox Assignment for Auto-Answering Mode (216)
This setting assigns auto-answering to mailboxes.
Audio Quality (228)
This setting specifies the audio quality for playing back greetings and messages.
Message/Greeting for an External Analog Line (230)
This specifies whether a message/greeting should be played for an external analog line.
7.2.13

Digital trunk settings

The HiPath 1100 systems can be equipped with digital trunks by means of a S
access) and a TME1 (E1 CAS/S2 access).
TME1 Module
E1 CAS Access:
E1 CAS access allows the system to use Caller ID and direct dialing to extensions, reducing
the number of lost calls and simplifying access for the user. The HiPath 1150 and the HiPath 1
can be equipped with one TME1 module (configured for up to 15 standard channels or 20
expanded channels). The HiPath 1190 can be equipped with two TME1 modules.
When only E1 digital lines are used, you only need to program the External Number
Registration. Country Code and Area Code can be left blank.
Access S2:
Provides connection to ISDN through primary access (30-channel) with capacity for using all
services offered by the network. The HiPath 1150 can be equipped with one TME1 module
(configured for up to 1 channels). The HiPath 1190 can be equipped with two TME1 modules
(one configured for up to 30 channels and the second one for up to 15 channels).
When the total number of digital trunks configured for the module plus the number of external
analog lines exceed the maximum capacity of the system, the external analog lines for the EB
202, 206 and 210 expansion modules are disabled. The extensions, however, will continue to
work as usual. Lines are disabled in the order that they are physically installed (1, 2, etc.). This
process continues until the total number equals the required number of external lines. The
remaining modules continue operating as usual.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
module (/ISDN
0
7-63