Run Quick Test - Siemens HiPath 1100 Service Manual

Configuring the system specifically for the client
Table of the System's Programming Codes
Programmed Cod
Functions e
Sensor activation 174
logic
Time between 050
Attempts for Acti-
vating the Sensor
MSN Assignment 051
for the Sensor
Number Dialed by 052
Sensor Activation
Number of 053
Attempts for Acti-
vating the Sensor
DTMF signals for 177
the Relay
*
Relay 175
Timer for Deacti- 173
vating the Relay
External Ring for 071
Activating the
Relay
* When playing music from an external music source all regulations relating to copyrights for the country in question have
to be followed.
Table 7-22 Relay and sensor on the HiPath 1120
7.1.1

Run quick test

Checking terminals
Check the display of each terminal (for Time and Date). If there is nothing on the display, it
●
means that there is a problem with the terminals or cables. Replace the terminal or inspect
cables.
Check analog terminals.
●
Checking to see if the systems starts up properly
Make random internal and external calls.
●
7-26
Intermediate Data
Extension
Data to be
Programmed
0 - Contacts closed
1 - Contacts open
Time: 00 to 10 minutes
Slot: 001 to 140 or
∗
- To delete
Number (up to 20 digits)
001 to 100 (attempts)
Number (up to 20 digits)
# - To confirm
1 - Switch
2 - Monoflop
3 - Invert
4 - Music on Hold
5 - External signal
000 to 255
(intervals of 0.5 s)
A31003-K1160-S100-03-7620
Completing Default
Data Entry
# instead of 0 - Contacts
the sensor closed
Automatic 03 (3
minutes)
Automatic None
Automatic or None
#
Automatic 001 (1
attempt)
Automatic or # None
Automatic 1 - Switch
# instead of 002 - (1
number second)
Automatic None
Service Manual