Figure 6-38 Windows Me - Selection For Isdn - Siemens HiPath 1100 Service Manual

5. A message will appear informing that a driver has been found. Click "Next" to proceed.
6. The installation of the USB drivers is confirmed. Click "Finish."
7. A message will appear informing that optiPoint is being searched. Repeat hardware driver
installation (steps 1 through 6):
To install administration drivers + CAPI Interface follow these steps:
8. During installation of optiPoint (CAPI Interface) configure these two settings:
9. A message will appear indicating that the best driver for the hardware has been found.
Click "Next" to proceed.
In the next window select "EUROISDN (DSS1)" and click "Next":
●
Figure 6-38 Windows ME - selection for ISDN
Enter an available extension number in the "Phone # (MSN)" field (for HiPath 1120/1150
●
the valid extension range X-Y). Click "Next" to confirm. The same window appears again.
Click "Next" one more time without entering anything in any field:
A31003-K1160-S100-03-7620
Service Manual
Operation
Driver Installation
6-40