Installation
Select the location for installing the equipment
4.3
Select the location for installing the equipment
Installation Location
The system's installation site has been previously selected and agreed to by the client.
The following precautions must be taken:
Do not expose the equipment to any external heat source (e.g., sunlight, heaters, etc.);
●
Do not expose the equipment to excess dust
●
Do not install the equipment in areas where there is a risk of condensation when the
●
equipment is in use. If condensation occurs, dry the equipment before starting operation.
Do not install inside closets.
●
The power outlet for connecting the system's power supply must be located close to the
●
equipment and must be easily accessible.
Follow all environmental guidelines described in the chapter "System Data" (see
●
"Environmental Conditions" on page 2-10).
No wall-mounting on walls subjected to vibration.
●
Warning
!
When using the RSA version, extension lines with a C/D interface must only be in-
stalled indoors. Only regular extensions (without a C/D interface) can be installed
outdoors.
Note 1: See Section "HiPath 1100 Configurations" on page 2-2 for more information
regarding system configurations.
4.4
Unpacking System Components
Procedure
Step
1.
Check to see that all components listed on the receipt are included in the package.
2.
Inspect all items for any damage that may have occurred during transportation. If
any damage occurred, report it immediately to the place of purchase.
4-4
Procedure
A31003-K1160-S100-03-7620
Service Manual