Siemens HiPath 1100 Service Manual page 303

In order for all MSN numbers to be entered the remote seizure mode must be configured as
PMP (Point-to-Multipoint) and the system number must not have been specified in the Manager
tool (Advanced->System Settings ->Country/Language Settings). If the operating mode is PP
(Point to Point) only the system number will be registered. You must configure MSN numbers
(Basic->MSN->Settings). Any MSN number previously configured must be deleted.
Automatic MSN Assignment facility provided by a local carrier only works if you also
subscribe to Call Forwarding on the public network.
S Ports (HiPath 1190) (062)
0
This setting specifies the operating mode for the S0 module maximizing the system's port
usage.
This option is best for the HiPath 1190 due to its high port capacity. The goal is to obtain a
maximum number of extensions/external lines allowed in relation to the following port detection
rules:
External line and extension (default): Each port will decrease the number of external line slots
by 2 and extension slots by 1. The connection may be PP, PMP or S0 Bus line (see item
Operation Mode");
External line only: Each port will decrease the number of external line slots by 2. The
connection must be PP or PMP. If it has been previously configured as a S0 Bus line, the
connection will automatically be reversed to PP (which is the default).
Extension only: Each port will decrease the number of extension slots by 1. The connection
must be a S0 Bus line. If it has been previously configured as PP or PMP, the connection will
be automatically reversed to S
After completing the configuration, the system must be restarted.
S Line Operation Mode (190)
0
This setting specifies the type of connection, either Point-to-Point, Point-to-Multipoint, or S
Bus) between the S
With the HiPath 1120, the S
cannot be programmed as an S
With other switches, the first port may also be configured as a S
A31003-K1160-S100-03-7620
Service Manual
Bus line.
0
module and the local carrier's lines.
0
0
Configuring the system specifically for the client
Comments about the System's Programming Codes
module's first port can only be a trunk, PP or PMP . It
bus.
0
0
Bus.
0
7-65