Siemens HiPath 1100 Service Manual page 275

Waiting Message before Signaling a UCD Call (032)
This feature allows you to connect a call waiting message for incoming calls before they ring at
an extension.
Minimum Time for Call Waiting Message in a UCD Queue (033)
This setting specifies a minimum length of time until a message is played for calls waiting in a
UCD Queue (032).
This feature works only when the Time in a UCD Queue option is enabled (Code
031).
Hunt Groups (HG) (021)
This setting allows you to group extensions into a maximum of 10 Hunt Groups (780 to 789).
A Hunt Group (HG) is a group of extensions assigned for answering calls made to a specific
number.
When an extension does not answer an internal or external call within a specified period of time,
the call rings consecutively at the available and the busy extensions in the group. When no one
is not available, the extension may disconnect from the Hunt Group.
This feature works only for digital lines.
Call Forwarding within a Hunt Group (HG) (223)
This feature works only for digital lines. It provides Call Forwarding for extensions belonging to
Hunt Groups. When a call is directed to a group, it ring at each extension, according to the
group settings (linear or round-robin) When an extension is set for Call Forwarding, calls are
routed to the destination as configured. If a call is not answered, the other extensions in that
group do not ring. When no Call Forwarding is set, calls ring at the other extensions, as
configured for the Hunt Group.
External Call Forwarding cannot be used for an extension that belongs to a group
when "Call Deflection" (Code 228) is activated (does not work for analog lines).
In this case the system does not receive any information about the forwarded call
having been answered or not. Since the system does not have this information, it
continues to signal all other group members.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-37