Preparing The Transducers - FujiFilm SonoSite Edge II User Manual

Preparing the transducers

WARNINGS
Cautions
Note
To use the transducer

For general use, apply a liberal amount of gel between the transducer and the body.
WARNING
To apply a transducer sheath

For invasive use, apply a transducer sheath.
FUJIFILM SonoSite recommends the use of market-cleared, transducer sheaths for intracavitary applications.
To lessen the risk of contamination, apply the sheath only when you are ready to perform the procedure.
1 Place gel inside the sheath.
2 Insert the transducer into the sheath.
3 Pull the sheath over the transducer and cable until the sheath is fully extended.
4 Secure the sheath using the bands supplied with the sheath.
Getting Started
Some transducer sheaths contain natural rubber latex and talc, which can cause
allergic reactions in some individuals. Refer to 21 CFR 801.437, User labeling for
devices that contain natural rubber.
Some gels and disinfectants can cause an allergic reaction in some individuals.
To avoid damage to the transducer, use only gels recommended by FUJIFILM
SonoSite. Using gels other than the one recommended by FUJIFILM SonoSite
can damage the transducer and void the warranty. If you have questions about
gel compatibility, contact FUJIFILM SonoSite or your local representative.
FUJIFILM SonoSite recommends that you clean transducers after each use.
Refer to Chapter 8, "Cleaning and Disinfecting."
Acoustic coupling gel must be used during exams. Although most gels provide
suitable acoustic coupling, some gels are incompatible with some transducer
materials. FUJIFILM SonoSite recommends Aquasonic
sample with the system.
To prevent contamination, the use of sterile transducer sheaths and sterile
coupling gel is recommended for clinical applications of an invasive nature. Do not
apply the transducer sheath and gel until you are ready to perform the procedure.
®
gel and provides a
2-19