FujiFilm SonoSite Edge II User Manual page 108

3 Do the following for EPI and then for Endo:
a Select the measurement name from the calculations menu.
b Position the caliper where you want to begin the trace, and press the SELECT key.
c Using the touchpad, trace the desired area.
To make a correction, select Undo on-screen or press the backspace key.
d Complete the trace, and press the SET key.
e Save the calculation.as described in
4 Select Apical from the calculations menu.
5 Positioning the calipers, measure the ventricular length. See
6 Save the calculation.
To measure Inferior Vena Cava (IVC) Collapse
1 On a frozen 2D image or M Mode trace, press the CALCS key.
2 From the calculations menu, select the measurement name.
3 Adjust the distance of the calipers using the touchpad.
4 Save the calculation as described in
To calculate Proximal Isovelocity Surface Area (PISA)
The PISA calculation requires a measurement in 2D, a measurement in Color, and two measurements in
Doppler spectral trace. After all measurements are saved, the result appears in the patient report.
1 Measure from Ann D (2D):
a On a frozen 2D image, press the CALCS key.
b From the calculations menu, locate PISA, and then select Ann D.
c Position the calipers.
d Save the calculation as described in
2 Measure from Radius (Color):
a On a frozen Color image, press the CALCS key.
b From the calculations menu, select Radius.
c Position the calipers.
d Save the calculation.
3 On a frozen Doppler spectral trace, press the CALCS key.
4 Do the following to measure from MR VTI and again to measure from MV VTI (Doppler):
a From the calculations menu, select PISA and then select MR VTI or MV VTI.
b Position the caliper at the start of the waveform, and press the SELECT key to start the trace.
c Using the touchpad, trace the waveform.
To make a correction, select Undo on-screen, backtrack with the touchpad, or press the backspace
key.
d Press the SET key to complete the trace.
5-24
"To save a calculation"
"To save a calculation"
"To save a calculation"
on page 5-8.
"Working with calipers"
on page 5-8
on page 5-8.
Measurements and Calculations
on page 5-1.