Software Licensing - FujiFilm SonoSite Edge II User Manual

Software licensing

FUJIFILM SonoSite software is controlled by a license key. After you install new software, the system
prompts you for a license key. You must obtain one key for each system or transducer that uses the software.
The software will operate for a short time (the "grace period") without a license key. During the grace period,
all system functions are available. After the grace period, the system is not usable until you enter a valid
license key. Grace period time is not used while the system is off or asleep. Grace period time remaining
appears on the license update screen.
Caution
To obtain a license key for your software, contact FUJIFILM SonoSite Technical Support. Refer to
help" on page 1-2.
You need to provide the following information. Refer to
Table 7-1: License key required information
System Software
Name of institution installing the upgrade
Serial number (on bottom of system)
ARM version
PCBA serial number
After you obtain a license key, you must enter it into the system.
To enter a license key
1 Turn on the system. The license update screen appears.
2 Enter the license key in the Enter license number field.
3 Select Done on-screen.
Note
4 If you upgraded a transducer package, the transducer package license update screen appears. Enter the
transducer package license key, and then select Done.
Troubleshooting and Maintenance
After the grace period expires, all system functions except licensing are
unavailable until a valid license key is entered.
Transducer Software
Name of institution installing the upgrade
Serial number (on bottom of system)
Transducer package version
PCBA serial number
If you entered a valid license key but the license update screen appears, verify that
you entered the license key correctly. If the license update screen still appears,
contact FUJIFILM SonoSite Technical Support. Refer to
page 1-2.
"System Information setup"
"Getting
on page 3-15.
"Getting help" on
7-3